Remote Control Reference
4-17
4.2.7 IEEE-488 Conformance Information
The following commands are used to command IEEE-488. Since most of them are described
above, limited information about the definitions of the dedicated hardware lines and
addressed commands are listed here.
*CLS
*ESE <enable value>
*ESE?
*ESR?
*IDN?
*OPC
*OPC?
*PSC {0|1}
*PSC?
*RST
*RCL <recall index>
*SAV <store index>
*SRE <enable value>
*SRE?
*STB?
*TRG
*TST
Dedicated Hardware Lines:
ATN – Attention
IFC – Interface Clear
REN – Remote Enable
SRQ – Service Request Enable
Addressed Commands:
DCL – Device Clear
EOI – End or Identify
GET – Group Execute Trigger
GTL – Go to Local
LLO – Local Lockout
SDC – Selected Device Clear
SPD – Serial Poll Disable
SPE – Serial Poll Enable
4.3
Programming Overview
This section provides an overview of the basic techniques used to program the power supply
over the remote interface.
4.3.1 Regarding Programming Ranges
62000L series is a power supply with the auto range feature. You don’t have to set values
depending on the range. The available programming value for a parameter varies according
to the desired output range of the power supply. Please refer to the following table to identify
the programming values.
