Christie DLV1280 DX, User Manual

Page: 77 / 143

OPERATION
3-44
DLV1280 DX User’s Manual
Figure 3.23. Use of Split Network Option
Whenever you install a new lamp in the
projector you must access the Lamp submenu
(available from Main) and record the lamp
serial number in the projector’s memory. You
can also choose the lamp operation mode you
prefer, such as maintaining a specific intensity
(light output) or power level, and define the
expected lamp life. Read-only information
includes the lamp serial number and age.
NOTE: See 4.4, Replacing the Lamp and
Filter for complete instructions on installing a
new lamp in the projector.
LAMP HOURS
shows the number of hours logged on the current lamp. Whenever you
record a new lamp serial number, this read-only value automatically resets to “0”,
where it begins to log time for the new lamp. “Lamp Hours” also appears in the
Status menu.
LAMP S/N
is the serial number recorded for the current lamp. When you install a new
lamp and enter its serial number, the read-only number will appear here.
Enter a checkmark for
LAMP MESSAGE
if you want to enable a warning message
upon power-up that the lamp has reached the specified lamp limit and should be
replaced. Delete the checkmark if you do not want to see this warning—instead,
when your lamp expires, only the status information on the back of the projector will
warn that the lamp limit has expired.
NOTES: 1) It is recommended that the Lamp Message checkbox remain enabled. 2)
When a lamp warning message appears, press
to temporarily cancel the
3.8 Working with
the Lamp
Figure 3.24. Lamp Menu