Christie DLV1280 DX, User Manual

Page: 54 / 143

OPERATION
DLV1280 DX User’s Manual
3-21
Most options for image adjustments can be accessed through two menus: Size and
Position (
Menu ) and Image Settings ( Menu ), both of which are listed in the Main
menu. While in either of these two menus, you can change settings affecting the
image from the current channel by working with the appropriate slidebars,
checkboxes and pull-down lists.
Exit will always return to the previous menu (or to
the presentation, if from the Main menu) and accept any changes you may have
made. Or you may prefer to begin with an automated setup in which the projector
quickly defines certain parameters for you—select Auto Setup from the Main menu.
These settings can then be fine-tuned in Size and Position and Image Settings at any
time.
From your presentation, you can access any of the individual options in these menus
by pressing
Menu
followed by the appropriate two-digit number representing their
location in the menu system. For example, press Menu
to quickly access the
“Color Setup” option in the Image Settings menu.
Note that for certain options, you may prefer to use a “direct key” from presentation
level to go directly to a particular option rather than traveling through the menu
system at all (note: this is not available for all display parameters). For example,
press
Cont to access the “contrast” slidebar immediately. Press Exit to return to your
presentation.
NOTES: 1) To hide the “direct” slidebars only, make sure the Display Slidebars
option in the Menu Preferences menu is unchecked. 2) To hide the entire menu
system from view, toggle the on-screen display OFF: press and hold the
OSD* key.
If you want the projector to quickly set up the image for you, select “Auto Setup”
from the Main menu. A confirmation box will ask if you really want to continue, in
which case display parameters listed in the Table below will be set for you. An “Auto
Setup” can save time in setting up an image, and you can also make further
adjustments as desired. You must have an unlocked channel present to use Auto Setup.
Table 3.2. Auto Setup
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Pixel Tracking Pixel Phase
Size Contrast & Brightness
Vertical Stretch Auto Input Level (off)
Position Blanking
Input Levels
(if analog source)
Detail
(if video source)
Filter
Luma Delay
3.6 Adjusting the
Image
Auto Setup
'