Christie DLV1280 DX, User Manual

Page: 43 / 143

OPERATION
3-10
DLV1280 DX User’s Manual
Func
= Red
Func
= Green
Func = Blue
Func
= Red and Green
Func
= Green and Blue
Func
= Red and Blue
Func
= All colors (
Exit does the same thing)
NOTE: Once Func is pressed in presentation level, the projector will not respond to
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
Use of the Func key within the menu system is noted with the appropriate topic
elsewhere in Section 3. For example, press Func in the Channel Setup menu to enable
deletion or copying of a channel.
OSD (On-screen display)
Press and hold OSD* for approximately 1 second to toggle menus on or off (i.e.,
visible or invisible). Or press OSD* followed immediately by ON or OFF
to
guarantee the correct toggle direction (useful if you are unsure of the present status).
Note that invisible menus are fully functional.
NOTE: With OSD on, you can still mute menus, error messages, slidebars, etc. with
the appropriate setting in the Menu Preferences menu.
Help
Press Help for detailed information about any current menu and highlight. Press Help
again to exit. From presentation level, press Help to access the General Help menu
consisting of Using Help, Setup, Keys, Source (Input) Selection, Status/Pwr LEDs
and Using 3D. Press
Exit to leave General Help and return to presentation level.
Test
Press Test to display one of the available test patterns. Press Test again to display the
next available pattern in the sequence. Test will exit after the last pattern, or press Exit
at any time to remove the current test pattern from the screen and return to
presentation level. Test patterns are also accessible from within the menu system.
NOTE: For a list of test patterns, see 3.7, Configuring System Parameters
(Communications menu).
Keypad operating settings (protocols)
The remote keypad and the optional wired keypad both store keypad operating
settings (called protocols) in memory. In some advanced applications, such as when
you want to use two separate keypads to control two projectors independently, you
may want to override the original protocol set at manufacture (which is "A or B") for
one of the keypads. See section 2.10, Keypad Protocols and Conversion for complete
instructions.
OSD*
Help
Test