Christie DLV1280 DX, User Manual

Page: 101 / 143

MAINTENANCE
4-6
DLV1280 DX User’s Manual
Figure 4.4. Detach lamp from terminal block
(TOP VIEW)
IMPORTANT
Detach the lamp from the terminal block only.
Do not disconnect cables.
Attach the terminal block and insert the new lamp
•
Secure the new lamp module to the terminal block with the single screw.
•
Insert the new lamp module into the lamp compartment. Looking into the
lamp compartment, the terminal block should be located at approximately “9
o’clock”, i.e., roughly centered and on the side of the lamp facing the projector
rear. Refer back to Figure 4.3 and Figure 4.5.
Figure 4.5. DX Lamp Orientation and Lead Dressing
WARNING
Check lead dressing in lamp compartment!
•
SECURE ALL LAMP CABLING
:
9
Make sure the heavy white (anode) cable is secured into the clip located
on the mesh shield (left wall of lamp compartment). This will prevent the
cable from touching the mesh shield.
9
Route the interlock harness over the lamp as shown in. Do not let it
dangle in front of the lamp.
STEP 6
'