Chicago Pneumatic CPF 270, Instruction Book

Page: 85 / 122

Control panel
Step Action
1 Regularly check the display for readings and messages. Normally, the main display is
shown.
2 Always check the display and remedy the problem if alarm LED (4) is lit or flashing.
3 The display will show a service message if a service plan interval has been exceeded or
if a service level for a monitored component has been exceeded. Carry out the service
actions of the indicated service plans or replace the component and reset the relevant
timer.
4 Regularly check the Inputs and Outputs menus for a quick look at the compressor status.
5.6 Stopping
Important
After pressing stop button (13), the compressor will run unloaded for 30 seconds. The
compressor stops after this period. A start command during this period is ignored.
After stopping, the compressor is prevented from restarting within a programmable time
(20 seconds). A start command given during this minimum stop time will be memorized;
the automatic operation LED lights up. The compressor will start when the minimum stop
time has elapsed.
Instruction book
2920 1796 01 83