Chery RIICH 2 series, User Manual, Page: 89 / 141

Emergency Procedures
80
Taillight Bulb
1. Replace the corresponding bulb
according to the following steps if the
taillight does not work due to damage.
2.
Open the back door and unscrew two
nuts that fix the taillight from the
internal side of luggage boot
counterclockwise. Then unscrew two
mounting bolts on the taillight surface
counterclockwise, pull off the harness
connector of taillight and take out the
taillight.
3.
Counterclockwise unscrew the bulb
shield according to the position as
shown in the figure.
Pull off the wiring harness on the bulb and
press the fasteners of bulb holder and
make them passing through the location
slot, then detach the fasteners to both sides
and take out the bulb, notice the alignment
mark of bulb.
4.
Notes: DO NOT touch the surface of
new bulb with hand to avoid the effect
on bulb brightness. Lighting system is
safety components, every detail for
replacement shall be prop er. Please get
to Chery’s special service station to
have it repaired if necessary.
The rear bumper must be removed when
replacing bulbs of rear fog lamp and
reversing lamp. Please get to Chery’s
special service station to have it repaired
in time if there is bulb failur e.
High-Mounted Brak ing Lamp
Bulb
High-mounted braking lamp bulb cannot
be replaced individually. Please get to
Chery’s special service station to have it
repaired in time.
License Plate Lamp Bulb
M ounting position: Above the rear license
plate.
1.
Unscrew the self-tapping bolts for
fixing license plate lamp and remov e
it.
2. Pull out the bulb holder and remove
failed bulb.
3. Install a new bulb in the bulb holder
and fix the bulb holder.
4. Fix it with self-tapping bolts.
Inte rior Front Ceiling Lamp
Bulb
Turn off interior lights.
Insert a screwdriver in the gap between the
lamp housing and lampshade, take out the
lampshade carefully.
Replace the bulb and install the reflector.