Chery RIICH 2 series, User Manual, Page: 37 / 141

Operation & Adjustment of Inside Devices
28
I. Introduction of
Vehicle Functions
Steering wheel lock/ignition
switch
Combined steering wheel lock/ignition
switch has the following key positions:
“B”
To lock the steering wheel, it shall turn it
after the key is pulled out till a click of
blocking is heard.
–Ignition switch turns off and the
steering wheel is blocked.
When the key is pulled out from the
ignition switch, the steering wheel lock
acts and t he steering wheel is blocked.
“I” –unlock the steering system. The circuit
of electric accessories is connected and
small electric appliance such as inside
lights can be operated. But the ignition
switch and main electric loop are
disconnected.
If the key could not or is difficult turn to
the position from
“B” , slightly turning the
steering wheel and then the locking system
of steering wheel may loosen.
The ignition switch key shall not be placed
at the position too long to avoid the power
of battery running out of.
“II” –Connect the ignition circuit. All
electric loops can work. Alarm lamps and
indicator lamps light. It is the normal
position of key during driving and the
position that must be selected for towing
the vehicle.
“III”
If the engine does not start, the key must be
turned to
“B” before restart, and then
turned to the position. After start, release
the key and it will return to
“II” position.
–Connect the motor and start the
engine. When the lock hole is at the
position, headlamps and electrical
equipment that consume more power will
be disconnected fully.
The ignition switch is equipped with
anti-repeatable start device inside. Once
the engine runs, the device may prevent
mis-start of engine, so that it avoids
damage from the engine and flywheel.
Once the engine started, the
key must be released. DO NOT
remain at “
III ” position for a long
time.