Chattanooga SENIOR SOLUTIONS, Service Manual, Page: 62 / 108

57
Senior Solutions™ Therapy System
6 REMOVAL/REPLACEMENT
FIGURE 6.15
CHANNEL 3/4 ELECTROTHERAPY MODULE SHOWN
Position the Surface EMG Module so that
the two mounting tabs are inserted into the
System or Electrotherapy Module mounting
slots.
See Figure 6.13.
Push the upper portion of the sEMG Module
until it snaps and is locked into position.
See
Figure 6.14.
Re-install module if required. Refer to 6.2
part C.
Route Power Cord through the Module and
connect to the Therapy System. Install all
cables, Lead Wires, etc. to the Therapy System
and Module where applicable.
Refer to
page 15 for symbol definitions. See Figure
6.15.
3.
4.
5.
6.
DISCONNECT THE SYSTEM FROM THE POWER
SOURCE (OUTLET OR REMOVE BATTERY MODULE IF
INSTALLED) BEFORE ATTEMPTING ANY MAINTENANCE,
INSTALLATION, REMOVAL, OR REPLACEMENT
PROCEDURES TO PREVENT ELECTRICAL SHOCK AND
POSSIBLE DAMAGE TO SYSTEM.
FIGURE 6.13
FIGURE 6.14