73
Vectra Genisys®/Intelect Legend XT®/ Intelect® Vet Therapy Systems
6 REMOVAL/REPLACEMENT
6.9 THERAPY SYSTEM STIM BOARD
CHANNELS
1/2
A. Tools and Equipment Required
#1 Phillips Screwdriver
Needle Nose Pliers
Flat Blade Screwdriver
B. Stim Board (Channels 1/2) Remova
l
Remove Channel 3/4 Electrotherapy, NiMH
Battery, or Laser Module, if installed.
Refer to
6.1
for instructions.
Remove sEMG Module if equipped.
Refer
to 6.2, part C.
Separate Top from Bottom.
Refer to 6.3,
part B
.
Remove Connector Board.
Refer to 6.7,
part B.
Remove Ultrasound Board on Combination
Systems.
Refer to 6.10.
Lay Therapy System on one side and use the
Flat Blade Screwdriver to remove the 1/4
Turn Fastener retaining the Stim Board in
position.
See Figure 6.37.
Remove System to Module Ribbon Cable
from System.
See Figure 6.37A.
Gently pull up on each corner and release
the plastic retaining tabs holding the Stim
Board in position.
See Figure 6.38.
C. Replacing Stim Board
Replace new Stim Board, part number 27056
in reverse order of
steps 1-8
above. Make
certain Jumpers are properly set on Stim
Board.
See Figure 6.38A
NOTE:
Position Ribbon Cable so the Blue Strip is
positioned as shown in
Figure 6.37A.
Press
on Stim Board while seating Ribbon Cable to
the system. On Combination Systems, install
the Ribbon Cable and 1/4 turn fastener
before installing the Ultrasound Board.
Re-assemble Therapy System.
Refer to
6.8 part C, 6.7 and 6.3, part C
for proper
instructions.
NOTE:
Do not over tighten the screws. Over
tightening will damage the threads of the
brass inserts.
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
FIGURE 6.37
FIGURE 6.38
SLOT 90° TO
LOCKED INDICATOR
LOCKED
INDICATOR
RELEASE LOCKING TABS ON
EACH SIDE OF STIM BOARD
FIGURE 6.37 A
REMOVE
RIBBON CABLE
BLUE STRIP
FIGURE 6.48A
CHANNEL 3/4
POSITION
CHANNEL 1/2
POSITION
DISCONNECT THE SYSTEM FROM THE POWER
SOURCE (OUTLET OR REMOVE BATTERY MODULE IF
INSTALLED) BEFORE ATTEMPTING ANY MAINTENANCE,
INSTALLATION, REMOVAL, OR REPLACEMENT
PROCEDURES TO PREVENT ELECTRICAL SHOCK AND
POSSIBLE DAMAGE TO SYSTEM.
