9
(13)
Power switch
: Turn on this switch to boot software. When shutting down, first
close the software and then turn off this switch.
9.
Booting the Machine
Turn on the power switch and then run
the “SmtMain” program. If camera device not
connected, close software, power down, unplug/plug USB cable and then turn on again.
Wait for the machine to load the operating system, self-check and perform an origin
reset. When the machine start is complete, the display screen is shown below.
Figure 9.1.
Top-level window, showing high-level functions.
(1)
Alarm:
Located upper left. View current alarm and cause;
(2)
Run:
Load working files and running the machine;
(3)
Diagnostics:
Diagnostic tests of module functions;
(4)
Set:
Set various parameters of the machine;
(5)
Job Statistics:
View the job record information;
(6)
System Logs:
View the system log;
(7)
Files:
Manage and convert work files.
