21
Batch is defined in two ways. One is by coordinate, where the user defines the origin
of each sub-board. The batch list must have at least one record, see below. The first origin
is always set with zero offset, ignoring the
“Place coordinate X\Y” value.
Figure
10.14.
Window after
“Run / Edit / batch tab”, listing batch steps.
The second batch method defines with an array, where each origin is calculated
automatically from the row and column spacing and count. Parameters can change
Figure
10.15.
Widow for editing array parameters.
with the
“Edit” popup window ,as show below.
(1)
PCB ID:
Only used in coordinate (not array) mode.
