2
−
12
62-11389
1. Blink once per second when data is being trans-
ferred to, or from, the PC Card. Will be on steady
when the operation is complete indicating the PC
Card may be removed.
2. During Download, after Card is read and identified,
card status LED blinks 2 seconds on and 2 seconds
off until the = key is pressed to start the programming
from the card to the micro. Once the data transfer to
the micro begins, the Card Status LED and the Micro
Status LED will blink together 1/2 second on and 1/2
second off until the data transfer is complete, then
the Micro Status LED will continue at the 1/2 second
rate and the Card Status LED will come on solid and
remain on solid until the card is removed from the
slot.
•
A red (PC) Card Fault LED blinks if there is a problem
transferring data from the PC card that has been
plugged into the PC card slot. The red LED will
continue to blink until the PC card is removed. The
LED will also blink if there is an error reading the card.
Check the MessageCenter for description of error.
PC
CARD SLOT
RUN RELAY (RR - Board
Relay K2) & LED28
F3
(7.5A)
SPEED RELAY (SR - Board
Relay K1) & LED 27
F2 (10A)
F1 (7.5A)
DC CURRENT
SENSOR (CT1)
FET LEDs
Refer to Table 5
−
1
4MP, IN/OUTPUT
CONNECTOR
1MP (WHITE)
IN/OUTPUT
CONNECTOR
2MP (BLACK)
IN/OUTPUT
CONNECTOR
3MP (GREY)
IN/OUTPUT
CONNECTOR
PC CARD FAULT LED
(RED)
PC CARD STATUS
LED (GREEN)
MICROPROCESSOR
STATUS LED (GREEN)
QC1 (12+VDC FROM
BATTERY)
QC2 (GROUND
FROM BATTERY)
RELAY POWER
QC8 (12+ VDC)
LED30 (GPR/IAHR)
LED31 (SSR)
QC4 (+12V
OUTPUT TO RR)
QC3 (+12V OUTPUT TO SR)
QC9 (FET ARC
SUPPRESSION)
5MP, IN/OUTPUT
CONNECTOR
6MP, IN/OUTPUT
CONNECTOR
MICROPROCESSOR
Figure 2
−
9 Control Module
