8
−
2
62-11389
Table 8
−
1 Maintenance Schedule
System
Operation
Reference
Section
a. Pre Trip Inspections
1 Pre Trip Inspection - before starting
2 Pre Trip Inspection - after starting
3 Run Microprocessor Pretrip - Before loading
4 Check Engine Hours
8.3
8.3
3.4
3.14
b. Every Service Interval
or Yearly
Engine
1 Check engine oil and filter change interval (refer to
Section
e.
of this table)
2 Check low oil pressure switch
3 Clean crankcase breather
4 Check engine speeds
5 Check water pump belt
Section
e.
Check
8.5.14
Table 2-1
Check
Fuel System
1 Clean mechanical and electric (if equipped) fuel pump screens
2 Change fuel filter
3 Check fuel heater (if equipped)
8.5.3 & 8.5.4
8.5.5
8.5.7
Cooling
System
1 Check coolant change interval (refer to Section
f.
of this table).
If replacement is not required, check antifreeze concentration
using a refractometer (Carrier Transicold part number
07-00435-00)
2 Clean condenser & radiator surfaces
3 Check water pump
4 Check water temperature sensor
8.5.12
8.5.12
Check
Check
Exhaust
System
1 Check mounting hardware
2 Check muffler and exhaust pipes
Check
Check
Air Intake
System
1 Change air cleaner filter element
2 Check and reset air cleaner indicator (if equipped)
8.5.9
Check
Starting
Circuit
1 Clean battery connections and cable ends
2 Check battery hold down clamps
3 Check battery condition
4 Check starter operation
Check/Replace
Check/Replace
Check
Check
Charging
Circuit
1 Check battery charger output voltage
2 Check battery charger amperage
2.11
2.11
A.C.
Generator
1 Check voltage output
2 Check amperage output
2.11
2.11
Unit
1 Check unit mounting bolts
2 Check engine and compressor mounting bolts
3 Check door latches & hinges
4 Check unit switches and electrical connections
5 Check all electrical ground connections
6 Check control box condition
Check
Check
8.4.3
Check
Check
Check
