![background image](http://html1.mh-extra.com/html/carrier/telink/telink_overview-and-setup-manual_2563790044.webp)
31
This field describes the result of the last outgoing alarm report or
user-initiated diagnostic alert.
Message
Result of Last Alarm
or Diagnostic Alert
Alm Ack
Alarm or alert was transmitted to
the site and acknowledged.
Success
Beeper call was sent successfully.
Failure
A failure status was received.
Disabled
Alarm processing is disabled.
Bad PW
Invalid password status returned
from the monitoring center.
Busy
Monitoring center is busy.
No Ack
TeLINK received no acknowledg-
ment.
Buf Full
Alarm buffer is full.
Valid Display
1 to 8 characters (See table above.)
This field contains the number of alarms or alerts that have been
transmitted to the monitoring center or beeper service successfully,
determined by the receipt of an acknowledgment.
Valid Display
0-65535
This field indicates that the alarm buffer is currently full of alarms
or alerts (contains 4), and TeLINK is in the process of trying to
report them.
Note:
A full alarm buffer will also affect alarm
acknowledgement. Refer to the explanation of the Alarm
Acknowledger decision in this manual's Configuration
chapter.
Valid Display
Yes/No
Last Alarm Call Result
Number of Alarms Sent
Alarm Buffer Full?
Summary of Contents for TeLINK
