SPE series
Function menu
12.16
Operating manual
45
Press key
to arrive at the next menu item.
Label error length:
In case an error occurs, indication after how many mm a message
appears in the display.
Value range: 1 mm
… 999 mm.
Synchronisation:
On:
If a label is missed on the liner an error message is displayed.
Off:
Missing labels are ignored, i.e. it is printed into the gap.
Press key
to arrive at the next menu item.
Flip label:
The axis of reflection is in the middle of the label. If the label width
was not transferred to the printer, automatically the default label width
i.e. the width of the printhead is used. It is recommended to use labels
with the same width as the printhead. Otherwise this can cause
problems in positioning.
Press key
to arrive at the next menu item.
Rotate label:
According to standard the label is printed ahead with a rotation of 0°. If
the function is activated, the label is rotated by 180° and printed in
reading direction.
Press key
to arrive at the next menu item.
Alignment:
The adjustment of label is effected only after 'flip/rotate label', i.e. the
adjustment is independent of the functions flip and rotate label.
Left:
The label is aligned at the left-most position of printhead.
Centre:
The label is aligned at central point of printhead.
Right:
The label is aligned at right-most position of printhead.
Press key
to arrive at the next menu item.
Measure label automatically:
On:
After switching on the printer, the loaded label is automatically
measured.
Off:
In order to start the measurement procedure you have to change
to the corresponding menu.
