Function menu
SPE series
56
Operating manual
12.16
7.9 Service functions
NOTICE!
So that the distributor res. the print module manufacturer at the
case of service can offer fast support, the print module is
equipped with the Service functions menu.
Necessary information such as set parameter can read directly at
the print module (see chapter 7.10, on page 59).
Press key
to access the function menu.
Press key
as long as you arrive at the 'Service functions'
menu.
Press key
to select the menu.
Label parameters:
Indication of label parameters in Volt.
A:
Indication of minimum value.
B:
Indication of difference between minimum and maximum value.
C:
Indication of trigger level. The value is ascertained while measuring
and can be changed.
Press key
to arrive at the next menu item.
Photocell parameters:
DLS:
Indication of transmission photocell level in Volt.
RLS:
Indication of reflexion photocell level in Volt.
SLS:
Indication of peel off photocell level in Volt.
TR:
Indication of transfer ribbon photocell status
(either 0 or 1).
H:
Indication of printhead position.
0 = printhead down
1 = printhead up
Press key
to arrive at the next menu item.
Paper counter:
D:
Indication of printhead attainment in meters.
G:
Indication of print module attainment in meters.
Press key
to arrive at the next menu item.
Heater resistance:
To achieve a high print quality, the indicated Ohm value must be set
after an exchange of printhead.
Press key
to arrive at the next menu item.
Printhead temperature:
Indication of printhead temperature. The printhead temperature
corresponds normally to the room temperature. In case the maximum
printhead temperature is exceeded, the current print order is
interrupted and an error message appears at the display of control
unit.
