Carl Valentin COMPA II, Operating Manual

Page: 62 / 116

Function menu Compa II
62 Operating manual 03.20
Press the key to move to the next menu item.
This function is activated e.g. if the transfer ribbon is to be changed. It
is avoided that a print order is processed although the module is not
ready. If the function is activated then press the key to change
between Online and Offline mode. The respective state is indicated in
the display.
Standard: Off
Online: Data can be received by interface. The keys of the foil
keyboard are only active, if you changed in the Offline mode with key
.
Offline: The keys of the foil keyboard are still active but received data
are not processed. If the module is again in Online mode then new
print orders can be again received.
Press the key to move to the next menu item.
Before the end of transfer ribbon, a signal is send by the control
output.
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control
output when reaching this diameter (measured at transfer ribbon roll).
Warning: When reaching the transfer ribbon advance warning
diamter, the corresponding I/O output is set.
Reduced print speed: Speed on which the printing speed is to be
reduced.
Error: The printing system stops when reaching the transfer ribbon
advance warning diameter with the message 'too less ribbon'.
Setting of the reduced print speed in mm/s. This can be set in the
limits of the normal print speed.
Press the key to move to the next menu item.
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the
same position on the label, the difference can be corrected in printing
direction.
NOTICE!
The value for zero point adjustment is set ex works. After
replacing the printhead, only service personnel are allowed to
set this value anew.
Online / Offline
Transfer ribbon
advance warning
Warning diameter
Ribbon advance
warning mode
Reduced print speed
Zero point adjustment
in Y direction