Function menu
Compa II
50
Operating manual
03.20
Press the key
to move to the next menu item.
The axis of reflection is in the middle of the layout. If the label width
was not transferred to the printer, automatically the default label width
i.e. the width of the printhead is used. It is recommended to use labels
with the same width as the printhead. Otherwise this can cause
problems in positioning.
Press the key
to move to the next menu item.
According to standard the label is printed ahead with a rotation of 0°. If
the function is activated, the label is rotated by 180° and printed in
reading direction.
Press the key
to move to the next menu item.
Corresponding to the parameter Rotate label, the label can be turned
in 90° steps.
NOTICE!
Only printer internal objects (text, lines and barcodes) can be
turned. The rotation of graphics is not possible.
Press the key
to move to the next menu item.
The adjustment of label is effected only after
Flip/Rotate label
, i.e. the
adjustment is independent of the functions
Flip label
and
Rotate label
.
Left:
The label is aligned at the left-most position of printhead.
Centre:
The label is aligned at central point of printhead.
Right:
The label is aligned at right-most position of printhead.
Flip label
Rotate label
Rotate label (in °)
Alignment
Summary of Contents for COMPA II
