Carl Valentin COMPA II, Operating Manual

Page: 69 / 116

Compa II Options
03.20 Operating manual 69
Press the key to move to the next parameter.
On: The start signal for the next label can already be released during
printing the current label. The signal is registered from the printer. The
printer starts printing the next label immediately after finishing the
current one. Therefore time can be saved and performance be
increased.
Off: The start signal for the next label can only be released if the
current label is printed to the end and the printer is again in 'waiting'
state (output 'ready' set). If the start signal was released already
before, so this is ignored.
Press the key to move to the next parameter.
Selection of the available configurations Std_Label (factory setting),
StdFileSetLabel or APL .
1 Print start and cut (Input)
2 Reprint last printed label (Input)
3 Counter reset (Input)
4 Option applicator only:
Start application (Input)
5 Error reset (Input)
6 Cancel all print jobs (Input)
7 No function
8 No function
9 Error (Output)
10 Print order active (Output)
11 Dispenser photocell:
Label exists at dispenser photocell (Output)
12 Printing (Output)
13 Ready (Output)
14 Option applicator only:
Ready for application (Output)
15 Option scanner only
Bar code not readable (Output)
16 Transfer ribbon prior warning (Output)
Save signal
I/O Profile
List of registered
functions for
Std_Label