Compa II
Additional Information
03.20
Operating manual
107
Dispenser:
After printing the label it is driven into the
dispenser offset and there waited. When
releasing a new start signal (IO dynamic) then the
next label is immediately printed. Because of the
fact that the label is already in the offset, the label
is only printed from beginning of offset position,
i.e. at the definition of label an accordingly large
range must be left free at the top margin of label,
because these data are otherwise not printed.
Cutter:
This is the same function as for 'backfeed
standard' as it is always backtracked after cutting
immediately to the beginning of label.
Tear-off edge:
After printing the last label of a print order it is
driven into the tear-off offset. When starting a new
print order, the next label is immediately printed.
Because of the fact that the label is already in the
offset, the label is only printed from beginning of
offset position, i.e. at the definition of label an
accordingly large range must be left free at the
top margin of label, because these data are
otherwise not printed.
If a following print order is available before driving
into the tear-off offset, then it is not driven into
tear-off offset but the following label is directly
printed.
Dispenser:
After printing the label, during driving into
dispenser offset the following label is 'pre-printed',
if this is already available (generated). When
releasing a new start signal (IO dynamic) the
already 'pre-printed' label is printed to the end and
when driving into the dispenser offset the
following label is again 'pre-printed'. In case the
following label is not yet available or at the last
label of a print order, the dispenser offset is driven
as until now, and then for the next label before
printing the backfeed to the beginning of label is
executed.
Cutter:
After printing the label, during driving into the
cutter offset the following label is 'pre-printed', if
this is already available (generated). After the cut
it is not backtracked but the already 'pre-printed'
label is printed to the end and when driving into
the cutter offset the following label is again 'pre-
printed'. If the following label is not yet available
or at the last label of a print order, the cutter offset
is driven as until now, then cut and afterwards the
backfeed to the beginning of label is executed.
Tear-off edge:
This is the same function as for 'backfeed
standard' as it is only driven into the tear-off offset
at the last label of a print order, if no following
print order is available.
No backfeed
Optimised
backfeed
Summary of Contents for COMPA II
