Carestream Quantum Odyssey HF QG-32, Operator'S Manual, Page: 61 / 102

Chapter 3 Operation
HF Series X-ray Generators - Operator’s Manual Revision Q
Quantum Medical Imaging, LLC
3-23
Battery 2
Discharged ERROR Faulty stored energy cell in
bottom battery tray (Anode on
two tray systems) or Line Mon-
itor/Charger board not
adjusted correctly. Call Technical Service/Support.
Battery NotRdy WARNING Battery voltage is too low.
(This warning message applies
only to stored energy genera-
tors.) Wait until READY light on Operator
Control Panel is steady before taking
exposure.
Battery
Overcharged,
Battery 2
Overcharged ERROR Line Monitor/Charger board
not adjusted correctly. Call Technical Service/Support.
Calibration ERROR Generator kV, mA, and/or fila-
ment calibration settings are
outside of acceptable limits for
normal system operation. Call Technical Service/Support.
Cathode Volt ERROR The filtered cathode volts are
outside of preset limits at any
time. Call Technical Service/Support.
Collimator ERROR Automatic collimator not
responding (only appears on
systems using an automatic
collimator). Call Technical Service/Support.
Door WARNING Entrance door to x-ray room is
open. Verify x-ray room door is closed and
re-take exposure.
Early Term WARNING Exposure terminated prema-
turely because EXPOSE key
was released before exposure
was completed. Press any key on Operator Control
Panel to clear warning message. Re-
take exposure.
Expose WDT ERROR Exposure sequence disabled
due to loss of communication
with EXPOSE watchdog timer. Call Technical Service/Support.
Filament Curr ERROR Indicates a problem with the
filament control regulator cir-
cuit voltage. Call Technical Service/Support.
Table 3-3. Fault Messages
MESSAGE/
INDICATION
MESSAGE
TYPE
DESCRIPTION REQUIRED ACTION