Carel EVD4, User Manual, Page: 32 / 48

32
Fig. 1
ENGL
ISH
EVD
4
+030220227 - rel. 2.1 - 12.06.2008
Below is a description of how to install and use the EVD4-UI confi guration and monitoring program
I.I Installation
To install the program:
- download the required EVD4_UI*.zip fi le from http:\\KSA.Carel.com;
- copy the contents of the EVD4_UI*.zip fi le to the required path on the PC (e.g.: C:\Program Files);
- the fi rst time that the program is used, edit the Destination item under the Link properties by entering
the path used on the PC:
I.II Preparing the connections
Connect the CVSTDUTTL0 converter to the EVD 4 controller, as explained in § 2.5.
I.III Preparing the user interface
The program does not require installation; simply copy the entire contents of the distribution directory to
the required location on the hard disk. The program cannot run from the CD as it requires write access
to the confi guration fi les.
Open the IN\EVD400UI.INI fi le from the path where EVD4_UI.exe is located and make sure that the
Paddr parameter is set to 1.
Start the EVD4_UI program using the shortcut icon to the application (see VII Confi gurations available)
and not the EVD4_UI.exe fi le, then press
and set:
• Port = COM address of the serial port used to connect the CVSTD*TTL0
• Baud Rate = 4800
• Parity = NO PARITY
• Byte Size = 8
• Stop Bits = 1
Press .
Now, if the converter is connected to an EVD 4 , image of the driver will be displayed in the top left and,
the EVD version window will show the following data
• Firmware rev. = = fi rmware version of the EVD
4 connected
• Param key rev. = parameter key version (for future use)
• Hardware rev. = hardware version
• Network address = network address of the main serial port
I.IV Saving the data
Pressing will open a dialogue box to save the entire memory of the EVD 4 :
choose a path and enter a name with the extension *.CFG, then press .
APPENDIX I. INSTALLING AND USING THE EVD4-UI PROGRAM