docs.carbide3d.com
62
Install Sweepy Dust Boot
Sweepy clamps directly to the router with a machined
quick-release.
1.
Fully seat the upper dust boot onto the router
body with the 36mm diameter dust port facing
forward and toggle the quick release to tighten.
See
Figure 10
-
11
.
2.
The lower half locks into place using neodymium
magnets for easy install and removal during tool
changes.
Install an End Mill
The Carbide Compact Router includes a 0.25” collet cone, a
collet nut, a 22mm collet nut wrench, a 13mm spindle
wrench, and the XXL kit comes with a #201 0.25" flat end
mill.
Installing the End Mill
1.
Clean and insert the end mill shank into the
loosened collet a minimum of 0.75" (20mm), the
entire length of the collet cone and nut. See
Figure 10
-
12
.
2.
Use the 22mm collet nut wrench and the 13mm
spindle wrench to tighten the collet nut securely.
See
Figure 10
-
13
. Alternatively, you can press and
hold the shaft lock while tightening with the 22mm
collet nut wrench.
Removing the End Mill
1.
To remove the end mill, follow the installation
procedure in reverse.
Figure 10-12
Figure 10-11
WARNING:
Never tighten the collet nut without
first inserting an end mill or the collet cone could
break.
Figure 10-13
Summary of Contents for SHAPEOKO XXL
