docs.carbide3d.com
16
Attach the Front Endplate
1.
Place the other endplate along the front of the
machine and slide it under the three cross straps as
shown in
Figure 2-11
.
2.
Adjust the endplate, cross straps, and MDF
baseplates so that all six screw holes align. See
Figure 2-12
.
3.
Use the 3mm hex key to insert six (6) M5x25mm
button head cap screws into the baseplate, through
the cross straps, and into the front endplate.
4.
Turn the screws until they stop but do fully tighten.
Figure 2-10
Figure 2-11
Figure 2-12
PRO TIP:
To further help with hole alignment,
shine a flashlight under the assembly to
illuminate the holes from the bottom. Adjust as
necessary. See
Figure 2
-
10
.
PRO TIP:
You can also try loosely inserting
screws from the center and working your way out
(i.e. center, left 1, right 1, left 2, right 2). Then
slowly tighten each screw in the same order. If
you are still having trouble getting the holes to
line up, contact us at [email protected].
Summary of Contents for SHAPEOKO XXL
