41
Use the 4mm hex key to remove the top two (2) M5x10mm socket head cap screws mounting the Y1-motor to the
Y1-carriage plate and replace them with the longer two (2) M5x16mm socket head cap screws. See
Figure 6-6
.
Once replaced, you will be able to see the screws protruding through the Y1-carriage as shown in
Figure 6-6
.
1.
Gather the remaining Y-Axis drag chain support
brackets.
2.
Use the 8mm wrench and two (2) M5 nuts to
secure the head bracket to the two protruding
M5x16mm socket head cap screws on the
Y1-carriage above the Y1-motor pulley. See
Figure 6-7
.
3.
Use the 3mm hex key and two (2) M4x6mm
socket head cap screws to attach the support
bracket (no PEM nut) to the outside of the Y1-rail.
Install closest to the front endplate. See
Figure 6
-
8
.
4.
Use the 3mm hex key and two (2) M4x6mm
socket head cap screws to attach the tail bracket
(single PEM nut) to the outside of the Y1-rail
closest to the rear endplate. See
Figure 6-8
.
Figure 6-6
Figure 6-7
Figure 6-8
Summary of Contents for SHAPEOKO XXL
