51
Required Components
See
Figure 8-2
:
Item
Description
Location
Qty
A
Controller Unit
XXL Final Assembly Box
1
B
PCB Riser Board (Adapter)
XXL Final Assembly Box
1
C
M6 x 12mm Button Head Cap Screw
XXL Final Assembly Box
2
D
Controller Unit Cover
XXL Final Assembly Box
1
E
3 Thumb Screws
XXL Final Assembly Box
3
F
M3 x 6mm Flanged Button Head Cap Screw
XXL Final Assembly Box
1
Required Tools
See
Figure 8
-
3
:
Item
Description
Qty
A
2 and 4mm Hex Key
2
Install the PCB Riser Board
The PCB requires an adapter to wire the polarized 3-pin
inductive proximity switches to the controller board.
1.
Remove the three (3) thumb screws holding the
cover in place.
2.
Use the 2mm hex key to remove the one (1)
M3x6mm flanged button head screw.
3.
Carefully remove the controller unit cover.
Inside the controller unit you will find two (2) M6x12mm
button head cap screws which are used to mount the
controller unit to the Y1-rail. Set these aside for a later
step.
Figure 8-3
WARNING:
When removing the cover, be careful
not to jar or damage the BitRunner adapter
extending out of the side of the controller (see
Figure
8-4
). You may find it helpful to remove the
Power/USB end first.
Figure 8-4
Summary of Contents for SHAPEOKO XXL
