35
6.
Use the 3mm hex key to reach in between the
X-motor and carriage plate, hook the loop, and
pull it up and out towards you. See
Figure 5-8
.
Make sure the belt has not twisted and the teeth
are still facing down, then place the belt loop over
the X-motor pulley. See
Figure 5-9
.
7.
Very gently take the slack out of the belt by slowly
pulling the free end toward the Y2-carriage.
8.
Attach another belt clip to the other end of the
belt. (Refer back to
Figure 5-4
.)
9.
Adjust the amount of belt you feed through the
second belt clip so that when it
’s
laid flat against
the X-rail (with the slack removed, but without
stretching it), a 1/4-inch gap exists between the
belt clip and the Y2-carriage. Ensure the teeth of
the bottom few inches of belt interlock with the
top. See
Figure 5-10
.
Figure 5-8
Figure 5-9
Figure 5-10
NOTE:
The belt should be tight enough to snap
against the Y1-rail when gently lifted.
Summary of Contents for SHAPEOKO XXL
