docs.carbide3d.com
36
10.
Use the 4mm hex key and one (1) M5x10mm
socket head cap screw to attach the belt clip to
the Y2-carriage. Insert the screw from the
OUTSIDE and tighten. Do not over tighten as this
could bend the X-motor pulley. See
Figure 5-11
.
Install the Y1-Rail Belt
1.
Attach a belt clip to one end of a second belt.
(Refer back to
Figure 5-4
.)
2.
Set the belt clip on top of the Y1-rail next to the
front endplate. The belt should lay flat, teeth
down, and extend along the Y1-rail towards the
Y1-carriage. Ensure the teeth of the bottom
2-inches of belt interlock with the top. See
Figure 5-12
.
3.
Use the 4mm hex key and one (1) M5x10mm
socket head cap screw to attach the belt clip to
the front endplate. Insert the screw from the
FRONT and tighten. See
Figure 5-12
.
4.
Feed the belt under the two idlers on the outside
of the Y1-carriage. Make sure the belt does not
twist and the teeth remain facing down all the
way to the rear endplate. See
Figure 5-13
.
Do not attach the other end of the belt just yet.
Figure 5-11
Figure 5-12
Figure 5-13
Summary of Contents for SHAPEOKO XXL
