8
Rigging
Spreader bars must be used and should extend past the edges of the equipment to avoid damage to the
casing. Not using spreader bars may cause damage to the unit casing. Refer to
for rigging
details.
WARNING: DO NOT LIFT UNIT BY THE INTAKE LOUVER, OR DOOR OPENINGS – USE ALL LIFTING
POINTS PROVIDED WITH A SPREADER BAR OR SLINGS UNDER THE UNIT – USE CARE NOT TO
DAMAGE COILS, SWITCHES OR PROTRUDING SHEET METAL COMPONENTS.
• Units are supplied with four lifting eyes on the bottom corners of the structural rails.
• Always use spreader bars to prevent damage to the unit casing.
• Test lift the unit approximately
2 feet
to verify proper center of gravity lift point. To avoid dropping unit,
re-position lifting point if unit is not level. Failure to properly lift unit could result in unit dropping and
possibly crushing operator/technician, which could result in death or serious injury and possible
equipment or property-only damage.
Figure 3 - Rigging (Size 2 Unit Shown)
WARNING!!
Ensure that all the lifting equipment used is properly rated for the weight of the unit being lifted.
Each of the cables (chains or slings), hooks, and shackles used to lift the unit must be capable of
supporting the entire weight of the unit. Lifting cables (chains or slings) may not be of the same
length. Adjust as necessary for even unit lift. Other lifting arrangements could cause equipment
or property damage. Failure to follow instructions above or properly lift unit could result in unit
dropping and possibly crushing operator/ technician which could result in death or serious
injury.
Spreader
Bar
Lifting Eyes
Located in 4 Corners
Lifting Eyes
Located in 4 Corners
Lifting Eyes
Located in 4 Corners
Lifting Eyes
Located in 4 Corners
Lifting Eyes
Located in 4 Corners
Forklift
Pockets
