Canon Oce Arizona 1200 Series, User Manual

Page: 68 / 226

Using Vacuum Zones - Metric Zones
Introduction
When the printer is shipped, the vacuum zones are configured to support either common metric
or imperial media sizes . The purpose of the vacuum zones is to reduce the preprint setup time by
reducing the need to mask the open area on the vacuum table when printing on the most
common size media.
The Océ Arizona 1200 Series GT has five control valves that determine the zones that are active
when the table vacuum pump is on. Zone 1 area is always active, and the five valves control
zones 2 through 6.
Metric Vacuum Zones
The following shows the locations and media dimensions associated with the factory-set metric
vacuum zones. The name of the zone indicates which vacuum handle controls that zone (except 1
as that zone is always on).
The metric configuration is designed such that zone 6 can be reconfigured by a service
representative from the 2.5m x 1.25m area size to 4'x8'.
[25] Metric Vacuum Zones
Print the Metric Zone Map
A map of the vacuum zones can be printed on the table to help with the position of media over
the zones. A default map is provided, but you can also create your own map, if desired.
Procedure
1. Select the Special Prints tab in the printer software.
2. Scroll to Vacuum Zones Metric - GT and add it to the print job list.
Using Vacuum Zones - Metric Zones
68 Chapter 5 - How to Operate Your Océ Arizona Printer
Océ Arizona 1200 Series