Canon iR1020 Series, Service Manual

Page: 58 / 304

Chapter 2
2-4
2) Remove the screw [1] securing the ground cable, and then separate the
card reader [3] from the card reader mount [2].
F-2-9
When removing the harness [1] through the opening in the card reader
mount, take care not to cut or damage it.
F-2-10
MEMO:
The removed card reader mount is no longer necessary.
3) Insert the card reader [2] harness and ground cable into the hole in the sup-
plied card reader mount [1]. Using the screw [3] removed in step 1) of "2.
Installation of the card reader", secure the card reader to the card reader
mount.
When inserting the card reader [2] harness and ground cable into the hole in
the supplied card reader mount [1], take care not to cut or damage them.
F-2-11
4) Using the supplied binding screw (M4x6) [1], connect the ground cable
[2] to the reader mount. Attach the supplied edge saddle [3] to the card
reader mount.
F-2-12
5) Attach the supplied cord retainer [1] at the position about 4 cm (A) away
from the connector (with a protective cover) of the supplied repeating har-
ness A. Cut out the excessive portion of the band.
F-2-13
6) Connect the connector [1] of the supplied repeating harness A to the con-
nector [2] on the card reader. Using the supplied binding screw (M4x6),
secure the repeating harness A clamp [4]. Disconnect the shorting con-
nector [5].
If the shorting connector [5] is not disconnected, a malfunction or error can
result. Therefore, the shorting connector must be disconnected.
MEMO:
The removed shorting connector is no longer necessary.
F-2-14
[2]
[1]
[3]
[1]
[1]
[3]
[2]
[1]
[3]
[2]
A
[2]
[1]
[2]
[3]
[4]
[1]
[5]