1
1
2
3
4
5
6
system recovery
cd-rom
hp
designjet copie
r
cc800ps
hp
designjet cop
ier cc800ps
Your printer
should already be
assembled and working before starting this
procedure. For instructions on how to
assemble the printer, please refer to the
assembly poster included with the printer.
Read these instructions carefully...
and complete each stage before you start the
next.
What You Will Need to Do the Job
Because some of the components of the copier
are bulky, you will need
2 or 3 people
to lift
them. See the descriptions that follow for
details, a symbol like this is used:
A note about fixings:
When initially assembling the copier stand
do not fully tighten the screws; you will be
asked to do this later.
Raise the
legs carefully
into the
upright position.
Attach the bottom bar to the other leg using 2
M6X10 screws.
Attach the
bottom bar to
the leg using 2
M6X10 screws.
Lay the 2 legs
down into the
position shown.
Secure the 2
legs by
fastening the cross
bar with 4 M6X10 screws (2 each side).
Attach the 2 feet
to the left and right
legs using 4
M6x30 screws (2
for each foot), tighten the screws with the Allen
key found in the assembly kit.
Assembly poster
2 Scanner
3 Rear Table
4 Top bar
with guide
5 Leg (x2)
12 Foot (x2) 13 Scanner
maintenance
sheet
14 Front panel arm
11 USB cables
8 Power
cables
16 Front
panel
15 Touch
screen
stylus
18 System recovery
cd-rom
10 Bottom bar
7 Assembly
kit
Assembly kit contents
Description
Quantity
Screw M6X10 for base and top bar
10
Screw M6X30 for base and top bar
8
Screw M4X25 for front panel arm
4
Allen Key 2,5mm for front panel
1
Screw M4X8 for front panel
5
Slotted special screw for scanner
4
Allen Key 5mm for Top Bar
1
Allen Key front panel arm
1
6 Maintenance
kit
1 Plastic dust
cover
9 Cross bar
17 Media guides (x2)
hp
designjet copier cc800ps
Assembly Instructions
