37
4
41
35
40
41
45
43
44
42
36
39
38
Connect the other power cable to the scanner.
Connect the scanner's power cable to a
power outlet.
Camera alignment & calibration...
(Height alignment, stitching, basic
calibration and color calibration)
You are now required to calibrate the
scanner, for this you will need the scanner
maintenance sheet, found in the protective
folder shown below.
If not done so already, connect the printer to a
power outlet and switch it on.
Important:
make sure that the
copier is turned on for at least one hour
prior to moving on to the next step of
camera alignment calibration. Slight
light intensity changes and camera
shifting can occur just after turning the
scanner on and warm-up time will
ensure that light conditions and camera
heights have stabilized.
1 hour
Note:
if on switching on the front panel a
'not present' message appears, please
press the 'Rescan' option on the front
panel.
Connect the front panel to the printer using the
longer USB cable and fastening with the clips
where shown (you must lift the rear table to
access some of the clips).
Switch on the scanner and leave it to warm up
for some minutes until the green (ready status)
light appears.
When the green (ready status) light has
appeared, switch on the front panel.
To start the maintenance procedure:
a) on the front panel menu press the setup tab
b) press the scanner button
c) press the scanner maintenance button
(shown above).
Ready status light
The maintenance wizard will ask you to insert
the maintenance sheet. The sheet's printed
side must be face down. Feed the paper in
aligning the two midpoint arrows. Press 'Next'
to continue.
Now follow the instructions that appear on the
front panel.
When calibration completes the maintenance
process; remove the scanner maintenance
sheet and return it to its protective cover. Store
the folder in a dry place away from light.
Note:
Your copier is now ready for use,
please make sure that the printer is loaded
with media and inks ready for use.
When System Administrators configure your
system in a network domain, they will also
need to setup automatic login. This procedure
is documented in 'how do I setup automatic
login' in your online help.
Adjust the USB cable to leave enough slack to
be able to pull out the printer when changing
paper.
Slack
