Canon imageCLASS MF4450, Basic Operation Manual

Page: 125 / 164

8-11
M
aint
enanc
e
5
Remove the toner cartridge.
6
Take out the new toner cartridge from the
protective bag.
You can open the protective bag with your hands from the notch.
7
Gently shake the toner cartridge five or six times
to evenly distribute the toner.
8
Place the toner cartridge on a flat surface, lift the
tab, and gently pull the sealing tape completely
out.
The full length of the sealing tape is approximately 20” (50 cm).
(2)
(1)
9
Insert the toner cartridge.
Fit the protrusions (A) on each side of the toner cartridge into the
guides located on each side of the machine,and then slide the
toner cartridge into the machine until the toner cartridge meets
the back of the machine.
(A)
(A)
10
Close the toner cover.
If you cannot close the toner cover
Ensure that the toner cartridge is properly set in the machine.
Do not try to forcefully close the toner cover, as this may damage
the machine.
11
Lower the scanning platform.
Precautions when Replacing Toner Cartridge
See “Maintenance and Inspections” (
→
P.ix) in “Important
Safety Instructions” as well.
WARNING
Do not dispose of a used toner cartridge in open
flames
This may cause the toner remaining inside the cartridges
to ignite, resulting in burns or fire.
CAUTION
Precautions if you get toner on your hands or
clothing
If toner gets on your hands or clothing, wash them
immediately with cold water.
Washing with warm water sets the toner, making it
impossible to remove the toner stains.
Be careful not to allow the toner to scatter
Do not pull out the sealing tape forcefully or stop at
midpoint, as this may cause toner to spill out.
If toner gets into your eyes or mouth, wash them
immediately with cold water and consult a physician.
Precautions when lowering the scanning platform
Be careful not to catch your fingers.