© 2001 Cannondale Corporation - All Rights Reserved
16
Motorcycle Parts and Controls.fm
F U S E S
The fuses for your vehicle are located inside fuse
holders under the seat.
Unless directed otherwise in a procedure, you
should always remove the fuses before working on
the vehicle.
Fuse replacement is described in the Maintenance
and Adjustment section of this manual.
S E RV IC E :
M ain fuse rating
10 A
S E RV ICE :
Lighting fuse rating
10 A
When a fuse blows repeatedly, it usually indicates
a short circuit or current overload in the electrical
system. The problem could be intermittent or
constant. In either case, don’t ride the vehicle
because an electrical fire could lead to a serious
accident. If you experience frequent fuse “blows,”
have the vehicle inspected by an authorized
Cannondale dealer.
O P T I O N A L L I G H T I N G
If you have an C440 or X440 model, you may
choose to install the available lighting systems. The
connection for optional lighting is located under the
seat near the main fuse and engine management
system relay. This connector is NOT protected by a
fuse, so do not improvise; contact your Cannondale
Motorsports dealer to install the optional lighting
system.
1. Main fuse
2. Lighting fuse
3. EMS power relay
POTENTIAL HAZARD
Using an unspecified fuse or shorting the fuse
holder.
1
2
3
WHAT CAN HAPPEN
Using a fuse with a rating other than specified or
using other materials in place of the fuse will cause
damage to the system. A malfunctioning electrical
system increases the risk that you may be seriously
injured or killed while operating the vehicle. For
example, an electrical fire can develop from a
system overload or you could lose vehicle lighting.
HOW TO AVOID THE HAZARD
Always use a replacement fuse of the specified
rating.
Never use other materials in place of the fuse.
If a fuse blows immediately after replacement have
the electrical circuits checked by an authorized
Cannondale Motorsports Dealer.
Check the condition of the wiring harness and
connectors before replacing a blown fuse.
Make sure the lighting is switched off when
replacing a fuse.
1. Optional lighting tap (non-fused)
2. Main fuse
3. Engine Management System power relay
1
2
3
