MEDIA SECTION 5
Page 5 —1
105 Valve
Media Loading Section 5.0
– Before you start to load the media, check all of the following:
**NOTE: FOR ANY UNITS WITH TOP MOUNTED CONTROL VALVES, IT IS CRITICAL TO BE
SURE THE DISTRIBUTION REMAINS CENTERED IN THE TANK AND STAYS ON THE BOT-
TOM OF THE TANK WHILE FILLING THE TANK WITH MEDIA. If the distribution is not
properly held down & centered, the media may have to be removed and redone. **
- Check the media list and confirm you have all the media re-
quired (see following tables). A large neck funnel will make the
media loading easier. Optional #99004
- Before the media is loaded, the bottom distribution must be
closely inspected to ensure it was not damaged in shipping. If
the distribution is cracked or broken, it must be repaired before
proceeding.
- If there are any riser pipes or any open distribution connections inside of the tank, en-
sure these connections are properly plugged so no media can enter them.
- Ensure the riser tube has been cut to the proper length and the riser end has been
smoothly beveled. NOTE: Depending upon the control valve used, the riser tube will have
to be cut to different lengths. On 95 series & 105 series control valves, the riser tube is
cut 1/2” below the top of the tank. With most other control valves, the riser tube is cut
flush with the top of the tank.
105 valves
Summary of Contents for 105STS 90 -1.5"
