Canature 105STS 90 -1.5", Installation, Operation & Service Instructions

Page: 76 / 94

General Maintenance Section 9
Page 9 — 18
Clean / Replace Injectors, DLFC, BLFC, And Meter Section 9.3
Caution: To prevent personal injury, or damage to the system, properly relieve the system
pressure before doing any servicing on the control valve, piping or on the media tank.
- Sediment, salt and silt will restrict or clog the injector. A clean water supply and pure salt will
prevent this from happening.
- Disconnect the brine line by removing the clip on the BLFC housing and pulling the housing
out. Also disconnect the brine solenoid wiring by using a Philips screw driver and unthreaded
the connector from the solenoid.
- Remove the four bolts holding the injector body on (use Phillips or 8 mm socket), and re-
move the injector assembly.
-The screen, throat and nozzle can be removed & cleaned. The throat & ball is removed from
the back and the nozzle & screen is removed from the front. After cleaning, reassemble the
injector assembly. Ensure all O-rings are lightly greased and installed correctly. See section 9.4
for recommended procedures for installing O-rings.
105 Control Valve