![background image](http://html1.mh-extra.com/html/campbell/et107/et107_product-manual_3806660093.webp)
Appendix C. PS24 24 Ah Power Supply and 10 x 12 inch Enclosure
C-8
7.
Install the solar panel above the 10-inch-by-12-inch enclosure, and face the
solar panel south (FIGURE
).
FIGURE C-9. Fully mounted solar panel
8.
Throw a blanket or box over the solar panel to prevent any voltage output.
9.
Route the solar panel cable and power cable coming from the main ET107
enclosure into the conduit at the bottom of the 10-inch-by-12-inch enclosure.
Leave a loop of all cables under the 10-inch-by-12-inch enclosure
to act as a drip line. Cut both cables to whatever length you need. It
doesn’t hurt to leave a loop of cable inside the enclosure.
10.
If this is a station retrofit, remove the PS100 or PS150 from the weather
station enclosure and install it into the PS24 enclosure. Unplug the 7 Ah
battery from the PS100 or PS150 and remove the battery from the battery
compartment. The 7 Ah battery will not be used in the configuration.
IMPORTANT