ET107 Weather Station
2
3. Initial Inspection
Immediately upon receipt of your shipment:
1.
Open shipping carton(s). Solar panel and radio frequency (RF) items (if
any) will be packed in a separate box.
2.
Set the large weather station carton down lengthwise on a floor or table
top.
3.
Position the box as shown in FIGURE
4.
Cut the tape along the edge of the lower flap first (FIGURE
).
FIGURE 3-1. Cut flap packing tape
5.
Cut the tape around the remaining flaps ensuring to only cut one layer
deep.
6.
Lift up the cardboard flaps exposing the top layer of foam (FIGURE
).
FIGURE 3-2. Shipping box packaging
7.
Check contents against invoice and shipping checklist (FIGURE
) and contact Campbell Scientific immediately about any
shortages.
Top Packing
Foam Layer
Middle Packing
Foam Layer
Bottom Packing
Foam Layer
ET107,
Top Layer
ET107,
Bottom Layer
Cut Lower Flap
Edge First