Campbell Hausfeld TL0501 Operating Instructions Manual Download

Page: 4 / 24

Operating Instructions

important safety instructions

(Continued)

Do not make any

modifications to

the tool without first obtaining written
approval from Campbell Hausfeld. Do
not use the tool if any shields or guards
are removed or altered. Do not use the
tool as a hammer. Personal injury or
tool damage may occur.

aiR soURCE

a .

Never connect to an air source that
is capable of exceeding 200 psi.

Over pressurizing the tool is able
to result in bursting, abnormal
operation, breakage of the tool or
serious injury to persons . Use only
clean, dry, regulated compressed air
at the rated pressure or within the
rated pressure range as marked on
the tool . Always verify prior to using
the tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range .

b .

Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.

Such gases are capable of explosion
and serious injury to persons .

Do not

use any

type of reactive gases,

including, but not

limited to, oxygen and

combustible gases, as a power

source. Use filtered, lubricated,

regulated compressed air only.

Use of a reactive gas instead of

compressed air may cause the tool

to explode which will cause death

or serious personal injury.

Use only

a pressure-regulated

compressed air source

to limit the air pressure

opERaTinG insTRUCTions

lUbRiCaTion

Proper lubrication is the owner’s
responsibility . Failure to lubricate the air
tool properly will dramatically shorten
the life of the tool and will void the
warranty .

This air tool

requires

lubrication before the initial

use and before and after each

additional use.

Air tools require lubrication throughout
the life of the tool . Air tool oil is
recommended because this oil cleans,
lubricates and inhibits rust all in one
step .

After an air tool

has been

lubricated, oil will discharge

through the exhaust port during

the first few seconds of operation.

Thus, the ex-haust port must

be covered with a towel before

applying air pressure. Failure to

cover the exhaust port can result in

serious injury.

1 .   Disconnect tool from air supply .
2 .   Turn tool upside down .
3 .   While pressing trigger, apply 5 - 10

drops of oil in the air inlet .

4 . Connect the air tool to the air supply

and cover the exhaust port with a
towel . Run the air tool for 7 to 10

seconds . Oil will discharge from the
exhaust port when air pressure is
applied .

RECoMMEnDED HooKUp

The illustration below shows the
recommended hookup for the tool .
1 . The air compressor

must be able to
maintain a minimum
of 60 psi when the
tool is being used . An inadequate air
supply can cause a loss of power and
inconsistent driving .

2 . An oiler can be

used to provide oil
circulation through
the tool . A filter can
be used to remove
liquid and solid impurities which can
rust or “gum up” internal parts of
the tool .

3 . Always use air supply hoses with

a minimum working pressure
rating equal to or greater than the
pressure from the power source if a
regulator fails, or 200 psi, whichever
is greater . Use 1/4 inch air hose for
runs up to 50 feet . Use 3/8 inch air
hoses for 50 foot run or longer .

4 . Use a pressure regulator on the

compressor, with an operating
pressure of 0 psi - 125 psi . A pressure
regulator is required to control
the operating pressure of the tool
between 60 psi and 90 psi .

200 psi or greater

3/8 inch I .D .

Recommended Hookup

Quick Plug

Quick

Coupler

Air Hose

Quick Plug

(Optional)

Quick

Coupler

(Optional)