Cambium Networks PTP 820C, User Manual

Page: 357 / 672

Chapter 11: Alarm Management and Troubleshooting Performing Diagnostics
phn-3963_004v000
Page 11-164
Table 58 SOAM MA/MEG Status Parameters
Parameter Definition
MA/MEG ID Automatically generated by the system.
MA/MEG Name
Format Reserved for future use. In the current release, this is Char
String only.
MIP Creation Reserved for future use.
Tx Sender ID TLV
content Reserved for future use. Sender ID TLV is not transmitted.
Port Status TLV TX Reserved for future use. No Port Status TLV is transmitted in
the CCM frame.
Interface Status TLV
TX Reserved for future use. No Interface Status TLV is transmitted
in the CCM frame.
MEP List Lists all local and remote MEPs that have been defined for the
MEG.
Configuring MEPs
Each MEP is attached to a service point in an Ethernet service. The service and service point must
be configured before you configure the MEP. See
Configuring Ethernet Service(s) .
To configure a MEP, you must:
1. Add MEPs to the relevant MA/MEG. In this stage, you add both local and remote MEPs. The
only thing you define at this point is the MEP ID. See
Adding Local and Remote MEPs .
2. Configure the local MEPs. At this point, you determine which MEPs are local MEPs. The system
automatically defines the other MEPs you configured in the previous step as remote MEPs. See
Configuring the Local MEPs .
3. Enable the Local MEPs. See Enabling Local MEPs .
Adding Local and Remote MEPs
To add a MEP to the MA/MEG:
1.
In the SOAM MA/MEG page, select a MA/MEG and click MEP List. The MEP List page opens.