Chapter 3: Configuration Guide
Configuring Link Aggregation (LAG)
phn-3963_004v000
Page 3-23
Figure 52 Create LAG Group – Final Page
9.
Click Submit. If all the interfaces meet the criteria listed above, a message appears that the
LAG group has been successfully created. If not, a message appears indicating that the LAG
group was not created and giving the reason.
Editing a LAG Group
To edit an existing LAG group:
1.
Select Ethernet > Interfaces > Groups > LAG. The LAG page opens.
2.
Select the LAG group you want to edit in the Link Aggregation table.
3.
Click Edit underneath the Link Aggregation table. The Link Aggregation - Edit page opens.
Figure 53 Link Aggregation - Edit Page
4.
Do one or both of the following:
o
To remove an interface from the LAG Group, select the interface in the Remove
Member field.
o
To add an interface to the LAG Group, select the interface in the Add Member field.
5.
Click Apply.
6.
To remove or add additional interfaces, repeat steps 4 and 5.
7.
When you are finished, click Close to close the Link Aggregation – Edit page.
