User Manual – Rev AJ
California Instruments
or PHASE A, this field can be used to program the trigger
phase angle (TRIG PHASE). In IMM mode, the value of this
field is ignored.
If the trigger source is set to SET VOLT, this field can be used
to specify the rms voltage to program the output to and trigger
oltage value set here should not
ms
or phases
TRIG DELAY
ield allows the trigger point to be positioned
information on data leading up to the trigger
n
ny more. The maximum value of the trigger delay is
lay value is 0.0 ms, which puts
the trigger event at the beginning of the acquisition window.
as
y
out triggering a new acquisition,
l
the measurement on. The v
exceed the maximum voltage range selected or the r
capability for the wave shape selected on the phase
programmed.
The trigger delay f
anywhere in the acquisition window. A negative value will
provide pre-trigger
event. The pre-trigger delay cannot exceed the length of the
acquisition buffer. See paragraph 4.6.3.3 for details. A positive
trigger delay positions the data window after the trigger event.
Positive trigger delays can exceed the length of the acquisitio
buffer in which case the trigger event itself will not be in the
buffer a
1000 ms. The default trigger de
START
The START field is used to start a new acquisition run. To start
an acquisition, place the cursor on the START field and press
the ENTER key. Once the ENTER key is pressed, the display
toggles to the data display mode selected in the VIEW field
soon as the selected trigger event occurs. To return to the
HARMONICS/TRACE ANALYSIS menu, press the ENTER ke
while in the data display mode.
To change display modes with
make the desired changes in the menu and move the cursor to
the VIEW field. Once on the VIEW field, press the ENTER key.
This will not trigger a new acquisition, which means the origina
data is retained.
MX Series
91