3.
Apply a thin coat of clean oil to the new oil filter gasket. Spin tighten.
Refill the crankcase with new oil. Follow specifications for type and
viscosity of the replacement oil. See Section E - Fuels and Lubrication, in
this manual.
4.
After new oil has been added, run the Engine at idle speed until the oil
pressure gauge indicates oil pressure. Check for leaks at the Filter and
Drain Plug. Re-tighten only as much as necessary to eliminate leakage.
If the Engine still will NOT start, consult your nearest authorized Engine dealer.
WARNING
NEVER service the fuel system while you are smoking, near an open flame,
with the Engine running or while the engine is hot. Sparks can ignite fumes
and/or spilled fuel.
Hydraulic Fluid Replacement
(500 Hours or Every Season)
The hydraulic fluid should be replaced every 500 hours, every season or sooner if
fluid becomes contaminated.
Stop the Engine and lower all attachments.
Drain the Reservoir (1-1/4” Drain Plug on bottom rear of Reservoir) and replace
the Plug. Fill the Reservoir with approved hydraulic fluid ONLY to level of
Lower Sight Gauge.
Start the Engine and operate all Cylinders. Raise the Boom and Tool Bar. Run
the Wheels and stop Wheels.
Stop the Engine and lower the Boom and Tool Bar to the ground. Fill the
reservoir, if needed, only to level of Lower Sight Gauge.
NOTE
Hydraulic System Schematics are included in the Parts Manual.
Exterior Cleaning
(As Required)
The machine should be washed (or steam cleaned) whenever excess dirt buildup
occurs. Be sure to lubricate all grease fittings after steam cleaning.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page60
V2.2
