f. Transfer:
erator must open the hand transfer valve then select direction and
The op
set speed.
g. Load:
e operator must select pump direction and set speed.
Th
h. Tank Circulate:
must select pump direction and set speed.
The operator
i. Reverse Suction.
ust select pump direction and set speed.
The operator m
II.
Spray-Bar Auto-Calibration:
achine startup or when a spray-bar sensor is
l in the OFF position
ar
r spray-bar if required
II.
Spray-Bar Sensor Calibration:
n be re-calibrated by doing the following:
he sensors (see fig. 3-3)
n procedure above.
Both spray-bars need to be calibrated on m
adjusted or replaced. To calibrate the spray-bar sensors perform the following.
a. Turn the Power ON
b. Put the Rear-Contro
c. Fully retract the Spray-Bar
d. Wait at least 2 seconds
e. Fully extend the Spray-B
f. Wait at least 2 seconds
g. Repeat steps c-f for othe
I
If a sensor is improperly calibrated it ca
a. Turn the power ON
b. Wait 5 seconds
c. Re- Disconnect t
d. connect the sensors
e. Follow the calibratio
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page35
V2.2
