FUELS
OTE
N
Due to chemical differences in petroleum products, the following lubricants
h
O
s
NOTE
and fluids are factory recommendations. Any lubricants, fuels or fluids whic
are NOT recommended here are used at your own risk. The manufacturer
responsibility for the results due to the use of any lubricants, fuels or fluid
which are NOT recommended.
assumes N
NEVER put additives in the fuel used in the machine unless specifically
Keep dirt, scale, water, etc. out of stored fuel. Do NOT store fuels for any extended
s
r
WARNING
recommended by your dealer.
periods of time. Fill the Fuel Tank after completing work at the end of each day. Thi
will reduce the problem of condensation forming in the tank overnight, which adds wate
to the fuel.
ALWAYS shut off the Engine when filling the Fuel Tank. ALWAYS ground
. If a
LUBRICATION
the fuel nozzle against the filler neck to avoid sparks. NEVER fuel the
machine when smoking or near a fire or open flame. Avoid spilling fuel
spill occurs, wipe it up immediately. NEVER add fuel when Engine is HOT!
Keep parts properly lubricated to prevent excessive parts wear and early failures.
WARNING
NEVER lubricate or service the machine while the Engine is running.
dure
p
SLOWLY
Lubricants
d Lubrications can be found on decals on the side of hydraulic tank.
Hydraulic System Filter Elements and Fluid
Controls Circuit
alent
OTE
ALWAYS BE SURE to exercise the Mandatory Safety Shutdown Proce
in Section A - Safety, of this manual, BEFORE proceeding to lubricate or
machine. When venting or filling the hydraulic system, loosen the Filler Ca
and remove gradually.
service the
Recommende
1.
10 Micron - Auxiliary Hydraulic
2.
7 Micron High Pressure Hydraulic Filter
3.
Hydraulic Suction Strainer
4.
Fluid - Mobile 424 or equiv
N
perator Services in Section H - Service, of this manual, for detailed
Refer to O
information regarding periodic checking and replenishing of lubricants.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page38
V2.2
