5.
Block the front and rear of the tires on the truck or trailer. If so
6.
), carefully drive the
CAUTION
equipped, engage the parking brake also.
Slowly drive the machine up to the ramps.
7.
Slowly (at the lowest Engine speed possible
machine up the ramps to the forward bulkhead of the trailer.
NEVER adjust travel direction (even slightly) while travelling on the ramps.
9.
Engage the Park Brake on the machine.
0.
Stop the Engine according to Mandatory Safety Shutdown
11.
NOTE
Instead, back down off the ramps and then re-align the machine with the
ramps.
1
Procedures in Section A - Safety, of this manual.
The forward tie down point is the front axle.
12.
The rear tie downs are the rear axle
ALWAYS use chains and chain binders. Do NOT lower tools to float
TRANSIT
position when loaded on transport vehicle. Tools in float position offer no
stabilization when vehicle bounces.
IN
f in transit for a few days, follow these guidelines:
1.
aise air pressure in tires several pounds above normal operating
2.
eze.
oat with heavy grease to prevent
5.
haust Pipe to prevent entrance of water.
When transporting the machine, know the overall height to allow clearance of
it will be
WARNING
I
R
pressure to prevent excessive bouncing.
Check cooling system for proper anti-fre
3.
Disconnect the Battery.
4.
Clean all bright surfaces and c
rusting.
Cover Ex
obstructions. Remove or tape over the slow moving vehicle emblem (SMV) if
visible to traffic.
If tire pressure has been increased for transport, it MUST be lowered to
operating pressure before the machine is placed back into service.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page42
V2.2
