TRANSPORTING
hen loading or unloading in a congested area, be sure flagmen are used to insure the
CAUTION
W
utmost SAFETY to the operator and other motorists and/or pedestrians in the area.
ALWAYS follow ALL state and local regulations regarding the operation of
OADING USING RAMPS
equipment on or across public highways! Whenever any appreciable distance
exists between job sites, or if transporting on a public highway is prohibited,
BE SURE to transport the machine using a vehicle of appropriate size and
weight.
L
OTE
N
ed pair of ramps is required.
G
A match
WARNIN
ALWAYS abide by the following recommended procedures and guidelines
1.
he ramps MUST be of sufficient strength to support the machine.
2.
ly attached to the truck or trailer bed
3.
length MUST be at
4.
be at least 1-1/2 times the tire width.
efer to Figure F-1 below.
ruck Bed & Top of Ramp MUST
Minimu
ST be 3.9 Times Height
when using ramps to load the machine onto (or unload it from) a truck or
trailer. Failure to heed these guidelines can result in damage to equipment
and serious personal injury or death!
T
Whenever possible, use strong steel ramps as well as some type of
center supporting block.
The ramps MUST be firm
with NO step between the bed and the ramps.
Incline of ramps MUST be less than 15° (ramp
least 16 feet long.
Ramp width MUST
R
T
be Even
m Ramp Length MU
Tire Blocking (Front & Rear)
Height
Sturdy Center Support
Less Than 15°
Figure F-1
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page41
V2.2
