Calder Brothers Mauldin Precision Spray, Owner/Operator & Parts Manual

Page: 50 / 87

I/O LIST DVC10 MacID=10
INPUT FUNCTION OUTPUT FUNCTION INPUT FUNCTION
DIG1 Tank Circulate UNI-1 Asphalt Pump RPM PWM-A PWM Pump
DIG2 Load UNI-2 Radar Sensor HS1 Pump CW
DIG3 Transfer UNI-3 Ground Speed HS2 Pump CCW
DIG4 Hand Spray P ANA-1 Left Bar Sensor WM-B
DIG5 Reverse Suction T-Bar 1’A (Curb) ANA-2 Right Bar Sensor HS3 L
DIG6 Clean Out ANA-3 Pump Potentiometer HS4 LT-Bar 1’ B
DIG7 Cab - P WM-C LT-Bar 1’ C
DIG8 Start Auto Clean - HS5 LT-Bar 1’ D
- - HS6 LT-Bar 4’ E
LED INDICATORS DVC10
NAME NO FAULT FAULT
POWER N
ING GREEN = INPUT VOLTAGE >30VDC·
SOLID GREE
BLINK
OFF = INPUT VOLTAGE <8VDC
STATUS OFF SEE FAULT CODE
MODULE REEN
DEVICE IN STANDBY STATE
LF-TEST
STATUS
(MS)
SOLID G
FLASHING GREEN =
FLASHING RED = RECOVERABLE FAULT
SOLID RED = UNRECOVERABLE FAULT
FLASHING RED/GREEN = DEVICE IS IN SE
NETWORK
OFF IF NO OTHER
THE
NS
EEN DETECTED ON
STATUS
(NS)
MODULES IN SYSTEM
SOLID GREEN IF
ARE OTHER
MODUALS IN
SYSTEM
FLASHING GREEN = DEVICE ON-LINE BUT HAS
NOT CONNECTED TO OTHER MODULES
FLASHING RED = ONE OR MORE CONNECTIO
ARE IN A TIMED-OUT STATE
SOLID RED = AN ERROR HAS B
THE CANBUS THAT WILL NOT ALLOW THE
MODULE TO COMMUNICATE
DIG 1 - 8 GREEN WHEN ON NA
HSOUT 1 - 6 N
IRCUIT
SOLID GREEN WHE
ON
1-BLINK/SECOND = OPEN C
4-BLINK/SECOND = SHORT CIRCUIT
PWM A – C ID RED TO SOLID
0%
SOL
GREEN WHEN ON
RED=0%
GREEN=10
FLASHING RED = SHORT CIRCUIT
FLASHING GREEN = OPEN CIRCUIT
Status Light
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page50
V2.2